Rowley NSG10 Spécifications télécharger pdf (Page 7)

6. Hold the pusher  rmly in one hand, with the other hand,

slightly stretch the spring, bend slightly, and hook the

spring onto the hook in the magazine cover slot

(Fig. 14). be careful not to over stretch the spring.

Fig. 14

7. Now one end of the spring is connected to the hook

in the magazine cover slot (Fig. 15-(1)) and the other

end goes around the tension roller and hooked on to

the pusher (Fig. 15-(2)).

Slide the magazine cover on the stapler while

pressing the magazine latch (Fig. 9)

Replace the bracket and fasten in the screw (Fig. 8).

How to Replace Other Parts

With use, some parts may break or

wear out. See the table below for stock

numbers of most replacable parts.

Order Lubricant Syringe (AS65) also.

AS65 will be used in the following steps.

NSG10 NS11

Piston NSG10/P15 NS11/P13

Bumper NSG10/P16 NS11/P14

Washer NSG10/P19 NS11/P17

Metal Washer NSG10/P20

no metal washer

Stapler

Parts

1. Unscrew the three bolts as shown in Fig. 16.

To remove the screw at the back end of the stapler,

use a wrench to keep the nut from spinning (Fig. 17).

Fig. 15

Fig. 16

(2)

(1)

Piston

Bumper

Washers

Fig. 17

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Rowley NSG10 Spécifications Page 7