Rowley NSG10 Spécifications télécharger pdf (Page 6)

Fig. 8

Fig. 9

Fig. 11

Fig. 12

Fig. 13

Fig. 10

With use, the pusher and pusher spring will be worn and need

to be replaced. Call Rowley Company to order the parts.

REPAIR & MAINTENANCE INSTRUCTIONS:

How to Replace Pusher and Pusher Spring

1. Undo the screw (Fig. 8) and remove the L bracket holding

the magazine cover.

2. Press the magazine latch (Fig. 9) to slide the

magazine cover off the stapler.

Look closely inside the magazine cover slot, at the nose

end, there is a tension roller for the pusher spring to go

around. In the bottom of the magazine cover slot there is a

hook for hooking one end of the pusher spring. Spring goes

around the tension roller and the other end of the pusher

spring connects to the hook on the pusher. See (Fig. 10).

3. Thread the spring behind and around the tension

roller into the magazine cover slot (Fig. 11).

4. Connect one end of the spring to the hook on the

pusher (Fig. 12).

5. Use a straightened paper clip or a T-pin to pull the

other end of spring out of the magazine cover slot,

while rmly holding the pusher (Fig. 13).

This end will be connected to

magazine cover slot hook in

Step 6.

Thread spring

around the

tension roller

This end will be

connected to the

pusher in Step 4.

Spring Go Around

Tension Roller

Magazine Cover

Pusher Spring

Pusher Hook

Pusher

Connect the other

end to Pusher

Hook

Connect one

end of spring to

the Magazine

Cover Hook

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire

Rowley NSG10 Spécifications Page 6

Commentaires sur ces manuels