IMPORTANT:Drop 3 drops of oil into the stapler air inletBEFORE rst use. See page 2.Please read the safety, operation and maintenance instructions BE
-10-• The warranty covers material and workmanship defects of the Long and Short Nose Upholstery Stapler (NSG10 & NSG11) sold by Rowley Co.• Th
11PARTS DIAGRAM & LIST FOR NS11:-12-# Part Name1 Bolt M5X202 Exhaust Cap3 Compression Spring4 Rectangle Washer5 Cylinder Cover6 O-Ring 11.7
The following diagram shows a simple compressed air set-up. Connect a filter to air compressor through a straight air hose. Connect the stapler to th
3OPERATION INSTRUCTIONS (cont.):3) Make Sure All the Screws Are Tight: Make sure the screw holding the L bracket (Fig. 6) is tight. If not, tigh
4Problem: Possible Cause: Corrective Action:1) Trigger can not be depressed.Trigger safety is in the way. Turn the trigger safety to the side.Warning:
5Problem: Possible Cause: Corrective Action:6) Stapler intermittently misres staples1. Worn washer See corrective action for problem (2).2. Incorrect
6Fig. 8Fig. 9Fig. 11Fig. 12Fig. 13Fig. 10With use, the pusher and pusher spring will be worn and need to be replaced. Call Rowley Company to order the
76. Hold the pusher rmly in one hand, with the other hand, slightly stretch the spring, bend slightly, and hook the spring onto the hook in
83. Unscrew the four bolts as shown in Fig. 19.2. Remove the magazine/nose assembly (1) and washers (2) (Fig. 18).4. Remove the bolts (1) and exhau
93456781610. Make sure the entire cylinder cover assembly is intact, all the parts are on, including compressed spring (3), rectangle wash
Commentaires sur ces manuels